Ensure you have internet connectivity to the DVR/NVR.

Q: I have my security system setup, but cannot view remotely on my phone or tablet.Ī: Check these items for troubleshooting: However, during fall 2016 the application will updated to “Guardian” and will have new features and an updated user experience. Q: Which mobile application should I use to view my DVR/NVR remotely?Ī: The Uniden ProHD application should be used from Apple/Android/Amazon stores. Q: I lost my administrator password, how do I reset it?Ī: For security purposes so that others cannot access your DVR/NVR with a default password, you must call customer care to enable your system to be reset. Settings > Basic > Alarms > Other Alarms > Drop down list to “Disconnect” > Turn off the “Buzzer” option by deselecting the checkbox > Exit To disable this, follow these instructions:

Upon startup, you should see the words “Upgrading” on the monitor screen. Download the file to a 2.0 USB flash drive and insert into the rear USB marked “USB 2.0” and restart your DVR. Update your firmware using the version above. Q: My new Guardian system beeps after I have set it up, what’s happening?Ī: There is a default buzzer when the DVR is not connected to the internet/LAN. When complete, disconnect the scanner.Need help finding answers to questions? Customer Support Knowledge Base Accept any following steps or acknowledgements indicated by the Sentinel program.ġ0. A window will appear listing connected Uniden scanners (only showing scanners connected via Mass Storage Mode - other scanners in use for Rangecast will not be shown, so there should be only one scanner listed.) Select this scanner.ĩ. In Sentinel, choose the drop-down menu Update from the navigation bar, then the option Update Firmware.Ĩ. If the message disappears, turn the scanner off and on again.)ħ. (Note: This message may time out after a few seconds, depending on your current firmware version. Select the Mass Storage option with the E key on the front panel of the scanner.

You will see a message like 'select USB Mode' (Mass Storage or Serial Port). Ensure the USB port on the front panel of the scanner is connected to the PC via a USB cable.Ħ. Download the Sentinel software from Uniden.Ĥ. This describes the steps necessary for updating the firmware.ġ. Updating firmware on Uniden 536Ī firmware update for the Uniden 536 issued in 2018 includes support for new features essential for Rangecast programming of this scanner model.

Uniden firmware